/**
 * Marlin 3D Printer Firmware
 * Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
 *
 * Based on Sprinter and grbl.
 * Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
 *
 * This program is free software: you can redistribute it and/or modify
 * it under the terms of the GNU General Public License as published by
 * the Free Software Foundation, either version 3 of the License, or
 * (at your option) any later version.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU General Public License for more details.
 *
 * You should have received a copy of the GNU General Public License
 * along with this program.  If not, see <http://www.gnu.org/licenses/>.
 *
 */
#pragma once

/**
 * Test X86_64-specific configuration values for errors at compile-time.
 */

// Emulating RAMPS
#if ENABLED(SPINDLE_LASER_PWM) && !(SPINDLE_LASER_PWM_PIN == 4 || SPINDLE_LASER_PWM_PIN == 6 || SPINDLE_LASER_PWM_PIN == 11)
  #error "SPINDLE_LASER_PWM_PIN must use SERVO0, SERVO1 or SERVO3 connector"
#endif

#if ENABLED(FAST_PWM_FAN)
  #error "FAST_PWM_FAN is not yet implemented for this platform."
#endif

#if HAS_TMC_SW_SERIAL
  #error "TMC220x Software Serial is not supported on this platform."
#endif