/**
 * Marlin 3D Printer Firmware
 * Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
 *
 * Based on Sprinter and grbl.
 * Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
 *
 * This program is free software: you can redistribute it and/or modify
 * it under the terms of the GNU General Public License as published by
 * the Free Software Foundation, either version 3 of the License, or
 * (at your option) any later version.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU General Public License for more details.
 *
 * You should have received a copy of the GNU General Public License
 * along with this program.  If not, see <http://www.gnu.org/licenses/>.
 *
 */
#pragma once

/**
 * Rapide Lite 200 v1 (RUMBA clone) pin assignments. Has slightly different assignment for
 * extruder motors due to dual Z motors. Pinout therefore based on pins_RUMBA.h.
 */

#define BOARD_INFO_NAME "RL200"
#define DEFAULT_MACHINE_NAME "Rapide Lite 200"

#if HOTENDS > 2 || E_STEPPERS > 2
  #error "RL200v1 supports up to 2 hotends / E-steppers. Comment out this line to continue."
#elif NUM_Z_STEPPER_DRIVERS != 2
  #error "RL200 uses dual Z stepper motors. Set NUM_Z_STEPPER_DRIVERS to 2 or comment out this line to continue."
#elif !(AXIS_DRIVER_TYPE_X(DRV8825) && AXIS_DRIVER_TYPE_Y(DRV8825) && AXIS_DRIVER_TYPE_Z(DRV8825) && AXIS_DRIVER_TYPE_Z2(DRV8825) && AXIS_DRIVER_TYPE_E0(DRV8825))
  #error "You must set ([XYZ]|Z2|E0)_DRIVER_TYPE to DRV8825 in Configuration.h for RL200."
#endif

#define E0_STEP_PIN                          26   // (RUMBA E1 pins)
#define E0_DIR_PIN                           25
#define E0_ENABLE_PIN                        27

#define E1_STEP_PIN                          29   // (RUMBA E2 pins)
#define E1_DIR_PIN                           28
#define E1_ENABLE_PIN                        39

#define Z2_STEP_PIN                          23   // (RUMBA E0 pins)
#define Z2_DIR_PIN                           22
#define Z2_ENABLE_PIN                        24

#include "pins_RUMBA.h"